Table of Contents
Advertisement
6.8
Dismantling and assembly, English
11. Sledge and ribbon cables
Fig. 9
12. Sledge motor and wire drive
13. Gearbox
14. Rear panel
Fig. 10
- Carry out the points 1 to 8, and remove the screws for the top plate (C, D, E), see
point 10.
- Remove the plastic strip over the well containing the ribbon cables and the wires
by lifting up the strip.
- Instal the red holder on the bracket for wires/cable, Fig. 9.
- Remove two screws from the cover over the CD mechanism.
- Lift the cover on the left-hand side and push it towards the right.
- Remove the two screws for the cover for the CD PCB. Remove the cover.
- Loosen 41P46 and 41P47, Fig. 6.
- Remove 35P53, power supply for the sledge motor.
- Remove three screws (H) for the bracket for wires/cable, Fig. 9.
- Loosen 26P96.
- Lift up the top plate with the sledge carefully. Look out for the lead and ribbon
cables.
- Place a holder, perhaps a Tyrap, around the wire drive by the motor.
- Loosen the spring on the right-hand side of the product. The spring is very tight.
Be careful not to let the sledge turn around.
- When the reassembly has been completed the sledge must not catch when it is
moved while it is being pushed down at the same time.
- Carry out point 11.
- Remove the wires from the sledge.
- Remove three screws and lift up the motor section.
- Watch out for the tacho disc.
- Assembly, if necessary see pictures on page 5.19.
- Carry out the points 1 - 5.
- Remove four screws. The gearbox can now be lifted out.
- Remember to instal the chassis spring when the product is reassembled. The
pointed end must be facing the top plate.
- Remove twelve screws (J) and lift it off. Watch out for the 8 ground connections .
- When the rear panel is installed the product must not be upside down. Place it in
upright position, for example.
Advertisement
Table of Contents
