Table of Contents
Advertisement
6.2
Dismantling and assembly, English
PCB5 Mains Relay
PCB7 Display
PCB9 Sledge Position
PCB11 Main Keyboard, left
PCB12 Main Keyboard, right
PCB13 Secondary Keyboard
PCB14 IR Receiver
PCB20 Master Link Interface
PCB21 Headphones
PCB22 Clamper Position
- Carry out points 1 to 5.
- Remove 35P53, power supply for sledge motor.
- Remove the screw for the cover over PCB5. Take off the cover. Do not cut the Tyrap.
- Remove the leads in 5P82 and 5P84, and loosen the lead between 5P83 and 34P16.
Make sure that the lead does not obstruct the wire.
- Carry out the points 1 and 6 to 8.
- If necessary, use one of the cables supplied at the back of the service manual
during servicing. Connect it between 34P8 and 7P63.
- Please note that the sledge runs at high speed when switching among the
individual CD's.
- Carry out points 1 to 5.
- Remove 35P53, power supply for sledge motor.
- The PCB is placed in service position.
- Carry out point 10.
- The PCB can be lifted up.
- Remember the chassis spring when reassembling.
- Carry out point 10.
- The PCB can be lifted up.
- Remember the chassis spring when reassembling.
- Carry out points 1 to 5.
- Remove one screw on the PCB.
- Carry out points 1 to 5.
- Remove 35P53, power supply for sledge motor, and 26P96.
- Remove the screws for the top plate (C, D, E) (see under point 10), lift the top
plate carefully (approx. 2 cm), and carefully pull the top plate a little to the right.
- Remove two screws for PCB14 and lift off the PCB.
- See PCB32.
- Carry out points 1 to 5.
- Remove 35P53, power supply for sledge motor, and 26P96.
- Remove the screws for the top plate (C, D, E) (see under point 10), lift the top
plate carefully (approx. 2 cm), and carefully pull the top plate a little to the right.
- Remove one screw. PCB21 can now be pulled up.
- When reassembling, make sure that the leads do not obstruct the sledge.
- Carry out point 14.
Advertisement
Table of Contents
