6.6
Dismantling and assembly, English
5. Chassis top plate
Fig. 4
6. Cover for CD clamper
7. Top plate for CD mechanism
8. Clamper arm
Fig. 5
- Carry out points 1 - 4.
- Switch off the product.
- Lift out the operating panel, and remove the nine screws marked A.
- Lift up and tilt backwards.
- Turn the cover until BANG & OLUFSEN is aligned with the hole, and then lift it off,
see Fig. 4.
- Carry out point 1 and point 6.
- Lift off the plate (it has some small barbs that hold it back).
- Carry out point 1 as well as points 6 and 7.
- Remove the three screws marked B and two fl at springs.
- Loosen 7P62 and 7P63.
- Push down the clamper holder and then lift.