Table of Contents
Advertisement
Test modes
TM (test mode) names/function for adjustments and service
Tuner test modes
Master test modes
CD test modes
WRONG SRC/TM
Because of the high complexity of BeoSound 9000 MKIII it is important to use the
built-in test and service functions during and after servicing the product.
A good approach to fi nding an error is test mode 27 in wich a report can be seen.
Remember always to execute test modes 71 and 73 after a repair situation.
TM 01: Automatic offset-adjustment for FM
TM 02: Manual offset-adjustment for FM
TM 03: Status for offset-adjustment
TM 04: Variant status
TM 06: Check RDS name
TM 07: Setting up of tuner variant
TM 20: Test of display functions
TM 21: Open ML-out
TM 22: Test of keyboard functions
TM 23: Software version
TM 24: Service operation counter
TM 25: Open ML-in
TM 27: Service of error detection
TM 28: Validity test for ROM/RAM/EEPROM
TM 31: Set default settings
TM 32: Read-out of product ID
TM 34: Read-out of options
TM 35: Power down ON
TM 36: Power down OFF
TM 61: Focus on
TM 62: Focus off
TM 63: Starts turntable motor
TM 64: Stops turntable motor
TM 65: Light pen to outermost position
TM 66: Light pen to the innermost position
TM 67: Starts CD
TM 68: Stops CD
TM 71: Mechanical test of fi nger protection, sledge and led
TM 73: Adjustment of autopositioning
TM 74: Safeguard level set to max
Having selected test mode, select CD before using test modes associated with CD
and select radio before using test modes assosiated with radio.
If you select a test mode that is not valid, e.g. a CD test while CD has not been
selected, the display will read:
WRONG SCR/TM
Test modes, English
5.3
Advertisement
Table of Contents
