Pcb24 Light Indication Right; Pcb25 Light Indication Left; Pcb26 End Stop Detector; Pcb28 Safety Rx - Bang & Olufsen BeoSound 9000 MKIII Service Manual

PCB24 Light indication right

PCB25 Light indication left

PCB26 End stop detector

PCB27 Safety TX

PCB28 Safety RX

PCB29 Lamp
PCB30 IR transmitter, tacho clamper
PCB31 IR receiver, tacho clamper
PCB32 Input/output Select and Sound adjustment
- Carry out points 1 to 5.
- The diodes can be removed through the "front".
- The PCB is riveted to the chassis top plate and cannot be removed any further. If
the PCB is removed, it MUST be fi xed again with double-sided adhesive tape.
- Carry out points 1 to 5.
- The diodes can be removed through the "front".
- The PCB is riveted to the chassis top plate and cannot be removed any further. If
the PCB is removed, it MUST be fi xed again with double-sided adhesive tape.
- Carry out points 1 to 5.
- Remove 35P53, power supply for sledge motor.
- Remove 26P96 and 26P75. The PCB holder can now be lifted up.
- Carry out points 1 to 8.
- Remove 35P53, power supply for sledge motor, and 26P96.
- Remove the screws for the top plate (see under point 10). Carefully pull the top
plate towards the right. PCB27 is fi xed under the top with a screw.
- Carry out points 1 to 8.
- Remove 35P53, power supply for sledge motor, and 26P96.
- Remove the screws for the top plate (see under point 10). Carefully pull the top
plate towards the right. PCB28 is fi xed under the top with a screw.
- Carry out point 1 and the points 6 to 8.
- Remove one screw for the PCB.
- Please note that the sledge runs at high speed when switching among the
individual CD's.
- Carry out points 1 and 6 and 7.
- Remove PCB29 and push up the Tacho holder. It is now possible to unclip PCB30.
- Please note that the sledge runs at high speed when switching among the
individual CD´s.
- Carry out point 1 and points 6 to 8.
- Remove PCB29 and push up the Tacho holder. Push out the PCB via the two small
holes from the opposite side of the Tacho holder.
- Please note that the sledge runs at high speed when switching among the
individual CD´s.
- Carry out points 1 to 5.
- Remove 35P53, power supply for sledge motor.
- Remove PCB1. Push in the clip on the right-hand side and lift up (at a slant) the
PCB for service.
P24, Headphones, may be removed if necessary.
Dismantling and assembly, English 6.3