Table of Contents
Advertisement
2. Left aluminium plate (grooved profi le)
Fig. 2
3. Release of sledge
Fig. 3
4. Cover for chassis top plate
- Lift the front edge on the left-hand side, push the plate to the left (it fi ts tightly),
and lift it off.
- The sledge can be released in four different ways:
a) With the product switched on.
- Carry out point 1.
- Carry out test mode 72 (CD72, see TESTMODES page 5.13).
b) If the product cannot be switched on.
- Turn the big gearwheel under the sledge (in the middle on the left-hand side)
clockwise. Use a screw driver, if necessary (be careful not to scratch the bottom),
Fig. 3.
- Or point c.
c) If the product cannot be switched on and the sledge is placed in positions 5 or 6.
- Carry out points 6 to 8.
- Remove the two screws for the cover for the CD PCB. Remove the cover by pulling
it to the left.
- Remove the plug for the clamper motor (41P45).
- The clamper motor terminals are now accessible. Apply +9V DC. The sledge will
now be released.
d) If the sledge is placed in position 6 and cannot be moved.
- Remove the rear panel of the product, see point 14. The sledge is released by
turning the big gearwheel.
- Carry out points 1 to 3.
- Push down the cover, tilt it out, and take it up, Fig. 3.
- Push the sledge into the notch that has been created.
Dismantling and assembly, English
BANG & OLUFSEN
BANG & OLUFSEN
6.5
Advertisement
Table of Contents
