Oce VarioPrint 2090 Safety Manual page 201

Mains connection
Never connect the machine to a mains voltage deviating from the value as
stated on the power-marking label. The power-marking label can be found at
the back of the machine on the right-hand side of the mains entrance, see figure
below. If connection to a different mains voltage is required, contact Océ
Customer Service.
[14] Location of the power marking lable
[14] Location of the power marking lable
Mains connection cable
The machine is connected with a detachable mains connection cable to the
mains. Do not use a different mains connection cable as supplied with the
machine. When replacement of the mains connection cable is necessary
because of damage or defect, contact Customer Service for proper
replacement.
Surroundings
Do not block the ventilation openings of the machine.
Ensure that the machine is placed on a level, horizontal surface of sufficient
strength. See the Océ VarioPrint 2090 safety data sheet in this Safety
manual for information about the weight of the equipment.
Ensure there is sufficient space around the machine. This facilitates
maintenance.
Do not place the machine in rooms which are subject to excessive vibration.
Do not place the machine in rooms which are too small and insufficiently
ventilated. See the Océ VarioPrint 2090 safety data sheet in this Safety
manual for information about the recommended minimum room volume
and ventilation.
Safety information 199