Remounting - Suzuki DR 125 Service Manual

• Install the new O-ring 1, washer 2 and spring 3.
• Install the brake cam lever as shown.
• Tighten the brake cam lever nut to the specified torque.
& Brake cam lever nut: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
• Apply SUZUKI SUPER GREASE "A" to the brake cam and
pin, and install the brake shoes.
% 99000-25030: SUZUKI SUPER GREASE "A" (USA)
99000-25010: SUZUKI SUPER GREASE "A" (Others)
'
Be careful not to apply too much grease to the cam
and pin. If grease gets on the lining, brake slippage
will result.

REMOUNTING

Remount the front wheel in the reverse order of removal. Pay
attention to the following points:
• Align the rib 1 on the left fork leg with the slot 2 on the brake
panel.
FRONT AXLE
• Tighten the front axle nut to the specified torque.
& Front axle nut: 35 N·m (3.5 kgf-m, 25.5 lb-ft)
• Install the new cotter pin.
• Adjust the front brake lever play. (!2-14)
CHASSIS 5-7