Wansview K2 User Manual page 14

Please note that motion detection doesn't work through windows. In this case we
recommend to connect an external motion sensor out of the window using the IO alarm
port.
Access to "Alarm Setting" to set Alarm Deployment, Alarm Action and Time Deployment.
Alarm Deployment
In the Alarm Deployment screen users can set:
IO Detection: sensor type can be chosen Always open and Always close. Always open
means external alarm device is needed, and only with alarm trigger, alarm will be valid. If
we choose Always close, the camera will be alarm continuously per 30 second.
Motion Detection Sensitivity: users can choose Low/ Middle/ High sensitivity according
to their needs.
Voice Detection Sensitivity: user can choose Low/ Middle/ High according to needs.
Temperature detection(K1): the temperate range can be set from -100℃to 100℃
"<" means the temperature below the set value, the camera will send alarm notification.
">" means the temperature above the set value, the camera will send alarm notification.
Humidity detection(K1): the humility range can be set from 0% to 100%.
"<" means the humidity below the set value, the camera will send alarm notification.
">" means the humidity above the set value, the camera will send alarm notification.
Attention: K2 has no such function in temperature and humidity detection.
Alarm trigger type
Trigger alone: The alarm will be triggered for any kind of active alarm event (Motion/
Voice/IO).
Trigger link: The alarm will be triggered for multiple detection at the same time (Motion/
Voice/IO).
Alarm Action
Once the alarm is set, users will receive a notification on the smartphone and can choose
to:
www.wansview.com
14