Chapter 3 - Hardware Design
6
BOARDS AND MODULES
Each product comprises a selection of PCBs (Printed Circuit Boards) and subassemblies, depending on the chosen
configuration.
6.1
PCBS
A PCB typically consists of the components, a front connector for connecting into the main system parallel bus via
a ribbon cable, and an interface to the rear. This rear interface may be:
Directly presented to the outside world (as is the case for communication boards such as Ethernet Boards)
●
Presented to a connector, which in turn connects into a terminal block bolted onto the rear of the case (as is
●
the case for most of the other board types)
Figure 9: Rear connection to terminal block
6.2
SUBASSEMBLIES
A sub-assembly consists of two or more boards bolted together with spacers and connected with electrical
connectors. It may also have other special requirements such as being encased in a metal housing for shielding
against electromagnetic radiation.
Boards are designated by a part number beginning with ZN, whereas pre-assembled sub-assemblies are
designated with a part number beginning with GN. Sub-assemblies, which are put together at the production
stage, do not have a separate part number.
40
P64x
P64x-TM-EN-1.3