Changing The Led Lamp; Troubleshooting - VESTEL Smart NFY 600 X User Manual

Changing the LED lamp

WARNING:LED lamp should not be
changed by the user.
If the light bulb is damaged, please contact
the Customer Communication Centre. Fol-
lowing steps can be followed for changing
the LED lamp:
• Remove the power plug from the mains
socket.
• Remove the cover of the lamp from its
right and left hand side using a screwd-
river by pressing down.
• Change the LED lamp and guide it to
its place correctly.
PROBLEM
Appliance is not
operating.
CAUSE
There may be a power failure.
Power plug may not be properly
connected.
Check if the fuse of the socket to
which the plug is connected or the
main fuse is blown.
Ambient temperature is too low.
There might be a problem with the
power outlet.
Freezer compartment may be in
automatic defrosting process.
Compressor may not work when it
is first started as a protection.
J

Troubleshooting

J
When you notice an abnormal situation
in your appliance, you may attempt to
troubleshoot according to the following
descriptions. If your appliance still does
not operate properly, contact Vestel Call
Centre. You may access the authorized
services list and contact information from
the web site.
SOLUTION
Contact with an expert electric tech-
nician.
Plug it firmly to the outlet.
Make sure that the fuse is operational.
Set the compartment temperature to
a lower level.
To check this, plug your refrigerator
to a socket which is surely operating
and try again.
It will get back to normal after the
defrosting process. This is normal.
It will get back to normal after a while
the appliance is switched on. This is
normal.
22