Connecting The Power Cord - Avery Dennison Mobile Work Station (MWS) Monarch 9876 Operating & Maintenance Instructions

C o n n e c t i n g t h e P o w e r C o r d
Make sure to set the proper voltage on the charger voltage selector switch
on the right side of the charger (115V in U.S. or 230V International).
Incorrect voltage selection can result in charger failure. Connect the
charger's power cord to the power inlet. Power cords are not included with
International models. The charger's power switch is also on the right side.
Charger
Power
Switch
Voltage
Selector
Power
Inlet
The battery's status LEDs are located on the left side of the Power Panel.
The MWS Power Switch is to the right of the LEDs. See Chapter 3,
"Charging the Batteries" for more information.
Do not plug the external power cord into a wall outlet until you
are ready to charge the battery. See Chapter 3, "Charging the
Batteries" for important battery information.
2-6 About the MWS
115
24VDC Charger
MWS
Power
Switch
Battery
Status LEDs
Power
Panel
Power
Cord