Connecting The Power Cable; Power Supply With Dust/Splash Guard Option; Connecting Sensors - Avery Dennison ALS 104 User Manual

3 B
EFORE OPERATION
3.1 E
LECTRICAL CONNECTIONS

Connecting the power cable.

Ensure that power switch [39A] is set to "O" (off).
Using the supplied power cable, plug the ALS 104
into a socket connected to the mains supply.
Power supply with dust/splash
3.1.2
guard option
ALS 104 labeller with dust/splash guard option
(IP65) may only be connected by qualified ser-
vice technicians.

Connecting sensors

3.1.3
Check whether the required sensors are connected
[40] before turning on the ALS 104.
The minimum required sensors:
– Label sensor (installation location: dispensing edge)
– Product sensor (installation location: conveyor belt)
You have the option of fitting additional sensors as well:
– Speed sensor (required for speed adaption)
– Outer diameter checking sensor (provides advance
warning of the end of a label roll)
You can find further information regarding suit-
able sensor types, pin assignments, and the
like in the service manual.
A
[39] Power cable (B) plugged in.
B
[40] Sensor connectors:
A Product sensor
B Label sensor
C Optional: Speed sensor
D Optional: Roll diameter (RD) sensor
34
B
C D
A
ALS
104
GB