Vmready Information Displays - IBM RackSwitch G8000 Application Manual

VMready Information Displays

© Copyright IBM Corp. 2011
The G8000 can be used to display a variety of VMready information.
Note: Some displays depict information collected from scans of a VMware vCenter
and may not be available without a valid vCenter. If a vCenter is assigned
(see "Assigning a vCenter" on page
available for up to two minutes after the switch boots or when VMready is
first enabled. Also, any major changes made through the vCenter may take
up to two minutes to be reflected on the switch unless you force an
immediate vCenter scan (see
Local VE Information
A concise list of local VEs and pre-provisioned VEs is available with the following
ISCLI privileged EXEC command:
RS G8000# show virt vm
IP Address VMAC Address
---------------- -----------------
*172.16.46.50 00:50:56:4e:62:00
*172.16.46.10 00:50:56:4f:f2:00
+172.16.46.51 00:50:56:72:ec:00
+172.16.46.11 00:50:56:7c:1c:00
172.16.46.25 00:50:56:9c:00:00
172.16.46.15 00:50:56:9c:21:00
172.16.46.35 00:50:56:9c:29:00
172.16.46.45 00:50:56:9c:47:00
Number of entries: 8
* indicates VMware ESX Service Console Interface
+ indicates VMware ESX/ESXi VMKernel or Management Interface
Note: The Index numbers shown in the VE information displays can be used to
specify a particular VE in configuration commands.
170), scan information might not be
"vCenter Scans" on page
Index Port VM Group (Profile)
----- ------- ------------------
4 3
2 4
1 3
3 4
5 4
0 4
6 3
7 3
170.
175
Chapter 14. VMready