Setup Part 5: Final Steps - IBM RackSwitch G8000 Application Manual

Setup Part 5: Final Steps

© Copyright IBM Corp. 2011
1. When prompted, decide whether to restart Setup or continue:
Would you like to run from top again? [y/n]
Enter y to restart the Setup utility from the beginning, or n to continue.
2. When prompted, decide whether you wish to review the configuration changes:
Review the changes made? [y/n]
Enter y to review the changes made during this session of the Setup utility. Enter
n to continue without reviewing the changes. We recommend that you review the
changes.
3. Next, decide whether to apply the changes at the prompt:
Apply the changes? [y/n]
Enter y to apply the changes, or n to continue without applying. Changes are
normally applied.
4. At the prompt, decide whether to make the changes permanent:
Save changes to flash? [y/n]
Enter y to save the changes to flash. Enter n to continue without saving the
changes. Changes are normally saved at this point.
5. If you do not apply or save the changes, the system prompts whether to abort
them:
Abort all changes? [y/n]
Enter y to discard the changes. Enter n to return to the "Apply the
changes?" prompt.
Note: After initial configuration is complete, it is recommended that you change the
default passwords.
43
Chapter 2. Initial Setup