IBM RackSwitch G8000 Application Manual page 188

186
RackSwitch G8000: Application Guide
4. Add the switch ports to their respective VLANs.
The VLANs shown in
RS G8000(config)# vlan 1
RS G8000(config-vlan)# member 22
RS G8000(config-vlan)# enable
RS G8000(config-vlan)# exit
RS G8000(config)# vlan 2
RS G8000(config-vlan)# member 1,2
RS G8000(config-vlan)# enable
RS G8000(config-vlan)# exit
RS G8000(config)# vlan 3
RS G8000(config-vlan)# member 3,4
RS G8000(config-vlan)# enable
RS G8000(config-vlan)# exit
RS G8000(config)# vlan 4
RS G8000(config-vlan)# member 5,6
RS G8000(config-vlan)# enable
RS G8000(config-vlan)# exit
Each time you add a port to a VLAN, you may get the following prompt:
Port 4 is an untagged port and its PVID is changed from 1 to 3.
5. Assign a VLAN to each IP interface.
Now that the ports are separated into VLANs, the VLANs are assigned to the
appropriate IP interface for each subnet. From
settings are made as follows:
RS G8000(config)# interface ip 1
RS G8000(config-ip-if)# ip address 205.21.17.3
RS G8000(config-ip-if)# ip netmask 255.255.255.0
RS G8000(config-ip-if)# vlan 1
RS G8000(config-ip-if)# enable
RS G8000(config-vlan)# exit
RS G8000(config)# interface ip 2
RS G8000(config-ip-if)# ip address 100.20.10.1
RS G8000(config-ip-if)# ip netmask 255.255.255.0
RS G8000(config-ip-if)# vlan 2
RS G8000(config-ip-if)# enable
RS G8000(config-ip-if)# exit
RS G8000(config)# interface ip 3
RS G8000(config-ip-if)# ip address 131.15.15.1
RS G8000(config-ip-if)# ip netmask 255.255.255.0
RS G8000(config-ip-if)# vlan 3
RS G8000(config-ip-if)# enable
RS G8000(config-ip-if)# exit
RS G8000(config)# interface ip 4
RS G8000(config-ip-if)# ip address 206.30.15.1
RS G8000(config-ip-if)# ip netmask 255.255.255.0
RS G8000(config-ip-if)# vlan 4
RS G8000(config-ip-if)# enable
RS G8000(config-ip-if)# exit
Table 18 are configured as follows:
(Add ports to VLAN 1)
(Add ports to VLAN 2)
(Add ports to VLAN 3)
(Add ports to VLAN 4)
Table 18 on page 185, the
(Select IP interface 1)
(Add VLAN 1)
(Select IP interface 2)
(Add VLAN 2)
(Select IP interface 3)
(Add VLAN 3)
(Select IP interface 4)
(Add VLAN 4)