Electrical system
TABLE D1
•
Place the connector on the opposite
side of the control unit and lower the
driving lever until the "click" that signals
the end of the stroke is heard.
TABLE D2
•
When the connector is fully inserted,
the distance between the connector
and the ABS control unit must be 7.5
mm (0.29 in)
TABLE D3
•
If the initial position of the connector
and driving lever is not as the one
shown in "TABLE D". The connector
will not be coupled correctly and the
measured distance will by greater, ap-
proximately 12 mm (0.47 in). In this
case, repeat the operations according
to the instructions in "TABLES D1/D2".
It is recommended to create a template
to check the correct insertion of the
connector.
ELE SYS - 64
V9 Roamer - V9 Bobber