V9 Roamer - V9 Bobber
•
Remove the spacer closing bearings.
•
Remove the sealing ring.
•
Remove the O-ring.
Checking
•
After assembly of the box, it is neces-
sary to check the play between the
pinion and the crown. Clamp in a vice
and install a dial gauge by means of a
suitable support. The dial gauge tester
must be placed the outer end of a tooth
positioned at 90°.
Characteristic
Maximum clearance allowed
0.10-0.15 mm (0.004-0.006 in)
Chassis
CHAS - 139