Ordering - GE Multilin F35 Instruction Manual

2.1 INTRODUCTION
52
2
Monitoring
50G
F35
Table 2–2: OTHER DEVICE FUNCTIONS
FUNCTION
Breaker arcing current (I
Breaker control
Contact inputs (up to 96)
Contact outputs (up to 64)
Control pushbuttons
Data logger
Demand
Digital counters (8)
Digital elements (48)
Direct inputs and outputs (32)
Disconnect switches
DNP 3.0 or IEC 60870-5-104 comms.
The F35 is available as a 19-inch rack horizontal mount unit or a reduced size (¾) vertical mount unit, and consists of the
following modules: CPU, faceplate, power supply, CPU, CTs and VTs, digital input and outputs, transducer inputs and out-
puts, and inter-relay communications. Each of these modules can be supplied in a number of configurations specified at the
time of ordering. The information required to completely specify the relay is provided in the following tables (see chapter 3
for additional details of relay modules).
Order codes are subject to change without notice. Refer to the GE Multilin ordering page at
http://www.GEindustrial.com/multilin/order.htm
NOTE
The order codes for the horizontal mount units are shown below.
2-2
79
CLOSE
50P 51P
2 1
51G
METERING
2 1
Transducer
TM
FlexElement
Inputs
Multiple Feeder Management Relay
Figure 2–1: SINGLE LINE DIAGRAM
FUNCTION
2
t) Ethernet Global Data protocol (optional)
Event recorder
Fault detector and fault report
FlexElements™ (16)
FlexLogic™ equations
IEC 61850 communications (optional)
Incipient cable fault detection
Metering: current, voltage, power, energy,
frequency, harmonics, THD
Modbus user map
Non-volatile latches
Non-volatile selector switch
F35 Multiple Feeder Protection System
2
Same Functions as Breaker 1
TRIP
50N 51N
For Breaker 1
2 1
27X 27P
TM
for the latest details concerning F35 ordering options.
2 PRODUCT DESCRIPTION
3 4 5
81U 59N 59X
6
2
832738A7.CDR
FUNCTION
Oscillography
Setting groups (6)
Teleprotection inputs and outputs
Time synchronization over SNTP
Transducer inputs and outputs
User-definable displays
User-programmable LEDs
User-programmable pushbuttons
User-programmable self-tests
Virtual inputs (64)
Virtual outputs (96)

2.1.2 ORDERING

GE Multilin