Additional Information; Customer And Technical Support - Patton electronics Serial G.SHDSL Bridge/Router 3087 Quick Start Manual

Connect the serial cable to the ipRocketLink serial port as follows:
Attach the male connector of the serial cable to the female serial connector on the IAD.
1.
Attach the other end of the cable to the serial connector on local serial NTU.
2.
The 3087's V.35 interface is wired as a DCE. No DTE configuration is possible. If you are directly con-
Note
necting the 3087's V.35 interface to a third-party equipment that cannot be configured as a DTE, you
must use a tail-circuit cable. You can purchase a tail-circuit cable from a datacom-supply vendor. A tail-
circuit cable will cross-over the necessary V.35 signals so that the two DCE interfaces can communicate.
The 3087's X.21 interface is default configured as a DCE. Changing the DTE/DCE strap internally can set
Note
the configuration for DTE. The 3087's X.21 interface requires a cable with a male DB-15 connector.
For detailed information about configuring and operating guidance, set up procedures, and troubleshooting,
refer to the ipRocketLink 3086 User Guide available online at www.patton.com/manuals/3086.pdf.
A.0 Customer and Technical Support
Toll-Free VoIP support: call
Online support: www.patton.com
E-mail support: support@patton.com—answered within 1 business day
Telephone support:
Standard: +1 (301) 975-1007 (USA), Monday–Friday: 8:00 am to 5:00 pm EST (1300 to
•
2200 UTC/GMT)
Alternate: +41 (0)31 985 25 55 (Switzerland), Monday–Friday: 8:00 am to 5:00 pm CET (0900 to 1800
•
UTC/GMT)
Fax:
+1 (253) 663-5693
6

7.0 Additional Information

sip:support@patton.com
(USA)
or +41 (0)31 985 25 26
with a VoIP SIP phone
(Switzerland)
Model 3087 Quick Start Guide