Patton electronics Serial G.SHDSL Bridge/Router 3087 Quick Start Manual page 4

IP Interfaces:
ID | Name | IP Address
---|------|----------------|----------|--------------
1 | ip1
----------------------------------------------
2. Modify the IP address for the LAN port according to your network requirements.
ip set interface ip1 ipaddress 10.10.10.5 255.255.255.0
fi
The above IP address (
Note
subnet as your PC.
Verify the new address is correct and save it in system boot memory.
3.
ip list interfaces <enter>
fi
system config save <enter>
fi
fi
3.0 Connect to the local IP network
Now you can connect the ipRocketLink to your local IP network and complete the remaining configuration from
your PC using a standard web browser.
Connect the ipRocketLink's Ethernet port (green) to the same Ethernet segment as your PC (see
front-panel Ethernet Link LED should turn on. If it does not, press the rear-panel MDI-X switch so that the Ethernet
Link LED illuminates.
You can check the connection with the ping command. For example shown in
10.10.10.5 from a PC on the IP network.
PC
4
| 192.168.200.10 | disabled | <bridge>
10.10.10.5/24)
Connect to Ethernet port
Ethernet port
Connecting the ipRocketLink to the local IP network
Figure 2.
| DHCP | Transport
is only an example. You must choose an IP address on the same
P o
1 0
w e
/ 1 0
r
0
C r
o s
E t
s o
h e
v e
r n
e t
M D
I - X
------
figure 2, you would ping
r
I n t
e r
f a c
e P
o r
t
D S
L
MDI-X switch
Model 3087 Quick Start Guide
2). The
figure