Console Port; Rear Panel Connectors And Switches - Patton electronics IPLink 2635 Getting Started Manual
Iplink series high speed routers
Hide thumbs
Also See for IPLink 2635:
- Specification sheet (16 pages) ,
- Specification sheet (2 pages) ,
- Getting started manual (133 pages)
Table of Contents
Advertisement
Models 2603, 2621, and 2635 Getting Started Guide
Link
T1/E1
LOS
TD
RD
TD
Sync Serial
RD
CTS
DTR
Link
Ethernet
100M
Tx
Rx
Console port
Located on the front panel, the unshielded RJ-45 RS-232 console DCE port (EIA-561) with the pin-out listed
in the following table:
Rear panel connectors and switches
On the rear panel from left to right are the following:
IPLink Series High Speed Routers overview
Table 2. Status LED descriptions (Continued)
Green
Solid green: connected
Off: disconnected
Red
On: indicates a T1/E1 loss-of-frame condition. It
also indicates that no T1/E1 signal is detected.
Green
Green: indicates a binary '0' condition
off : indicates a binary '1'or idle condition
Green
Green: indicates a binary '0'condition
off: indicates a binary '1' or idle condition
Green
Green: indicates a binary '0' condition
off : indicates a binary '1'or idle condition
Green
Green: indicates a binary '0'condition
off: indicates a binary '1' or idle condition
Green
ON: indicates the CTS signal from the router is
active, binary '1'
off: indicates CTS is binary '0'
Green
ON: indicates the DTR signal from the DTE
device attached to the serial port is active,
binary '1'
Green
ON: indicates an active 10/100 Base-T connec-
tion
Green
ON: connected to a 100BaseT LAN
Off: connected to a 10BaseT LAN
Green
Flashing: when transmitting data from the router
to the Ethernet
Green
Flashing: when transmitting data from the Ether-
net to the router.
Signal
Pin No.
Direction
1
Out
2
Out
3
In
4
—
5
Out
6
In
7
Out
8
In
1 • General Information
Signal
Name
DSR
CD
DTR
Signal Ground
RD
TD
CTS
RTS
21
Advertisement
Table of Contents
