Error Log; Snmp Daemon; Error Log And Syslog Settings - Patton electronics IPLink 2635 Getting Started Manual

Models 2603, 2621, and 2635 Getting Started Guide

Error Log

The Error Log webpage shows recent configuration errors and provides for the configuration of the Syslog. (See
figure 78.) Two parameters are configurable for the Syslog.
• Syslog Host: enter the IP address of the Syslog (Default = 0.0.0.0)
• Syslog Facility: select the type of syslog facility (Default = disabled)s
Click on the Update button to activate the selected parameters. Default value is a disabled Syslog.

SNMP Daemon

For remote management from an SNMP capable management station, the IPLink's SNMP Daemon must be
configured. To identify a specific IPLink, configure the Static Variables which the system administrator may
use for link identification.
The Community Table has three configurable parameters.
• Password: this is the password which the remote management station must use to access the IPLink for
reading/writing the SNMP variables.
• Management IP: the IP address of the management station.
• Access: select either Write or Read. The management station can be authorized to configure the IPLink by
'writing' to the SNMP variables or limited to a 'read'-only function.
To delete an entry, click on the 'Del' box and click on the Update button.

Error Log

Figure 78. Error Log and Syslog Settings
10 • System Configuration
102