Initial Configuration; Hardware Installation; What You Will Need; Interface Cable Installation - Patton electronics IPLink 2635 Getting Started Manual
Iplink series high speed routers
Hide thumbs
Also See for IPLink 2635:
- Specification sheet (16 pages) ,
- Specification sheet (2 pages) ,
- Getting started manual (133 pages)
Table of Contents
Advertisement
Models 2603, 2621, and 2635 Getting Started Guide
Hardware installation
If you are already familiar with IPLink Series Router installation and configuration, this chapter will enable
you to finish the job quickly. Installation consists of the following:
•
Preparing for the installation (see section
•
Installing the T1/E1 WAN, X.21, or V.35 interface cable (see section
•
Hooking up network cables, verifying that the unit will power up, and running a HyperTerminal session
(see section
"Installing the Ethernet cable"
CAUTION
•
Changing the IP address from the factory default setting (see section
•
Launching a web browser in preparation for configuring the modem (see
tion"
on page 37)
What you will need
•
IPLink Series High Speed Router
•
Ethernet cable with RJ45 plugs on each end (included with router)
•
DB9-RJ45 adapter (included with router)
•
RJ45/RJ45 straight-through cable for connecting to control port (included with router)
•
PC computer with HyperTerminal or equivalent VT-100 emulation program, or an ASCII terminal (also
called a dumb terminal) capable of emulating a VT-100.
Interface cable installation
An IPLink Series router comes with a T1/E1 WAN, V.35, or X.21 interface. Refer to the appropriate section to
install an interface cable on your IPLink router:
CAUTION
•
Model 2603 router (see
page 29)
•
Model 2621 router (see
•
Model 2635 router (see
Hardware installation
"What you will
on page 36)
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
"Installing an interface cable on the IPLink 2603's T1/E1 interface port"
"Installing an interface cable on the IPLink 2621's X.21 interface port"
"Installing an interface cable on the IPLink 2635's V.35 interface port"
3 • Initial Configuration
need")
"Interface cable
"IP address modification"
"Web Operation and Configura-
installation")
on page 37)
on
on page 31)
on page 33)
28
Advertisement
Table of Contents
