Administering User Accounts; Adding New Users; Setting User Passwords - Patton electronics IPLink 2635 Getting Started Manual

Models 2603, 2621, and 2635 Getting Started Guide
ip interface ip1 list secondaryipaddresses
Secondary IP addresses for interface: ip1
ID | IP Address
-----|-----------------
-----------------------
In this example there was not a secondary IP address.
ory with the following command.
system config save
Wait for the message that says "Configuration Saved", then reboot the modem with this command.
system restart

Administering user accounts

As admin user you can administer user accounts. This section summarizes the CLI commands which can be
used to administer user accounts.

Adding new users

To add a new user username, use the command: system add user < username >
system add login user < username > < Comment >
The first command creates a user who can access the system via a dialin connection using PPP for example.
The second command creates a user who can login to the system.
For example, the commands:
system add user fred user with dialin access
system add login joe user with login access
creates two new users called fred and joe. The accounts are created with no passwords. To view details about the
new users, enter:
system list users
The following information is returned:
Users:
May May Access
ID | Name | Conf. | Dialin
-----|--------|----------|----------|-----------|-------------------------
1 | fred | disabled | ENABLED | default
2 | joe | ENABLED | disabled | default
3 | admin | ENABLED | disabled | superuser | Default admin user
--------------------------------------------------------------------------

Setting user passwords

To change the password for the user you are currently logged in as, use the command:
user password
Enter the new password twice as prompted:
Enter new password: ***
Again to verify: ***

Administering user accounts

<enter>
Now save the entire configuration in nonvolatile FLASH mem-
| Level | Comment
| user with dialin access
| user with login access
E • Command Line Interface (CLI) Operation
< Comment >
132