Connecting And Logging In Via The Console Port; Configuring The Desired Ip Address; Factory-Default Ip Settings; Connecting The Onsite To Your Laptop Pc Via The Console Port - Patton electronics OnSite 2884 User Manual
T1/e1 channelized gigabit router
Hide thumbs
Also See for OnSite 2884:
- Getting started manual (52 pages) ,
- Quick start manual (9 pages)
Table of Contents
Advertisement
OnSite Model 2884 User Manual
Connecting and logging in via the Console port
To access the OnSite configuration via the console port, connect the DB9-RJ45 adapter to the DB-9 serial
port on the PC or dumb terminal. Use the RJ45 straight-through cable between the adapter and the console
port on the 2884. (see
figure
HyperTerminal session at 19200 bps, 8 data bits, 1 stop bit, no flow control, and no parity. Log into the unit
using the username admin. Leave the password field empty.
Figure 11. Connecting the OnSite to your laptop PC via the console port
2. Configuring the desired IP address
Factory-default IP settings
The factory default configuration for the Ethernet interface IP addresses and network masks are listed in
Both Ethernet interfaces are activated upon power-up.
Table 6. Factory default IP address and network mask configuration
LAN interface Ethernet 0 (ETH 0)
LAN interface Ethernet 1 (ETH 1)
If these addresses match with those of your network, go to section
on page 31. Otherwise, refer to the following sections to change the addresses and network masks.
Login
To access the OnSite, start the Telnet application. Type the default IP address for the router into the address
field: 192.168.200.10. Accessing your OnSite via a Telnet session displays the login screen. Type the factory
default login: admin and password: <blank>.
2. Configuring the desired IP address
11). Do NOT connect the device to the Ethernet LAN now. On the PC, start a
0 /3
0 /2
0 /1
1
0 /0
/E
T 1
A
, 1
H z
r
/6 0
w e
Connect to Console port
P o
5 0
V ,
4 0
2 0
-2
~ 1
IPLink 2884
o le
n s
C o
192.168.200.10
0 /1
3 2
H
-2
E T
R S
0 /0
H
E T
IP Address
192.168.200.10
192.168.1.1
"3. Connecting the IpLink to the network"
4 • Initial configuration
PC
DB-9 serial port
RJ45 to DB-9 adapter
Network Mask
255.255.255.0
255.255.255.0
table
6.
30
Advertisement
Table of Contents
