Restart; Website Settings; Restoring To Factory Defaults; Webpage Refresh Rates - Patton electronics IPLink 2635 Getting Started Manual

Models 2603, 2621, and 2635 Getting Started Guide
10 • System Configuration
Figure 75. Saving or reloading previously saved configuration files

Restart

From this webpage, you can do a soft reboot of the IPLink or restore the IPLink to factory defaults. To restore
to factory defaults, click on the box for Reset to factory default settings. (see figure 76.) Then click on the Restart
button. No warning is given before beginning the reboot process. You will need to configure the IP address of
the Ethernet port again as described in Chapter 3, Initial Configuration.
Figure 76. Restoring to factory defaults

Website Settings

The refresh rate of the webpages is a configurable parameter. Enter the desired refresh rate (in seconds) and
click on the Update button. Default value is 4 seconds. (See figure 77.)
Figure 77. Webpage refresh rates

Restart

101