System Dependent Phone Setting - Mitel 7147 User Manual

Set time and date
1. In idle state, press [save] for 3 seconds to enter the time/date setting mode
2. Enter the number for HH:MM DD/MM (or MM/DD depends on the date format selected). For
example, 17:30 28/06, press [1]+[7]+[3]+[0]+[2]+[8]+[0]+[6]. The corresponding digit of time/date
icon flashes to indicate which digit is being entered.
Set Ring Melody
1. During On-hook, press [save]+[#]+[0]+[2]+[#]+[X]+[#].
2. X could be set from 1 to 8 (melodies 1~8).
LCD Contrast
1. During On-hook, press [save]+[#]+[0]+[3]+[#]+[X]+[#]
2. X could be set from 1 to 4 (Level 1~4).
3.5

SYSTEM DEPENDENT PHONE SETTING

Message Waiting Function (MW)
The telephone is equipped with a Message waiting key with a built in LED. If you have a voice mail
box it is possible to get an indication on the telephone when you have received a new voice mail. Then
the LED will be lighted ON or flashing in blue. The voice mail box can be reached by pressing the MW
button.
Enable the MW function on your telephone
To enable the MW function it is required to make two settings:
I. Set the MW switch to the position that is supported by the telephony system. Alternatives are:
MW-, MW+, HV.
II. You must store the number to the voicemail box in the MW memory of the telephone.
I) Setting the Message Waiting Switch
The Message Waiting switch (at the back of the phone) is used to select the appropriate MW mode
(HV / + / - ). Please check which MW type the PBX system supports.
1. Set the MW switch
Note: If the LED is steady active, change the message waiting switch position.
II) Save your voice mail number in the telephone
1. Place the handset on the phone and press [
2. Press [
3. Press [
4. The "save" successes with confirmation tone
| LZT 102 4162 | Uen | PR2C | 2016-03-04|
] and enter the number to be saved
] key again to complete saving
]
Mitel 7147 User Guide – PR2C
19