Installation; Connecting The Twisted-Pair Line Interface - Patton electronics Model 1058 User Manual

Because the Model 1058 requires no configuration, it can be installed
and made operational quickly. Installation takes place as follows:
1. Connecting the line interface between the units (refer to section 3.1,
"Connecting the Twisted-Pair Line Interface" on page 7)
Note See Figure 2 for the rear panel arrangements.
2. Connecing the Ethernet interface (refer to section 3.2, "Connecting
the 10/100Base-T Ethernet Interface" on page 9).
3. Connecting the power plug (refer to section 3.4, "Connecting Power"
on page 11).
1058D
Ethernet

3.1 CONNECTING THE TWISTED-PAIR LINE INTERFACE

The Model 1058 supports communication between two peer Ethernet
LAN sites over a distance of up to 4,652 ft (1,418 m) over 24 AWG (0.5
mm) twisted-pair wire.
Note Actual distance and link performance may vary depending on
the environment and type/guage of wire used.

3.0 INSTALLATION

i n
d e
M a
r
w e
P o
k
L i n
S L
V D
e t
r n
h e
E t
VDSL twisted-pair
RJ-45 interface
port
VDSL twisted-pair
terminal block
interface
Figure 2. Model 1058 standalone rear panel
1058DV
A
U S
t h e
7
M a
P o
k
L i n
S L
V D
D N
/ I S
T S
P O
e t
r n
h e
E t
POTS/ISDN
twisted-pair
terminal block
interface
A
U S
t h e
i n
d e
r
w e
Power
jack