Installation - Patton electronics 1200 User Manual

Do the following to install the Patton Model 1200:
1. Configure according to the instructions listed in section 4.0, "Config-
uration" on page 7.
2. Turn off the computer or device to which the Model 1200 is to be
connected.
3. Plug the DB-25 connectors directly into the serial ports of your RS-
232 devices. If you wish to extend the distance, you can add cables
on both sides (see Figure 1).
Note
Sync. Host
(300 feet or less)

3.0 INSTALLATION

Cables must not be longer than 300 feet (see Figure 1).
Cable
Figure 1. Configuration
Model
1200
(300 feet or less)
6
Sync. Host
Cable