Mitsubishi Electric Melsec FX Series Beginners Manual page 106

Learning to Use the FX Family for Positioning Control
Writing data to the FX
Write the servo parameters, positioning parameters and table information to the FX
and Flash ROM by pressing the Write to module
boxes. Change the range of table data to be written to 0–25.
Fig. 4-45: Write to module window
Next, reset the module by pressing the System reset
servo parameters.
4 - 64
-20SSC-H
3U
FX3U-20SSC-H positioning
button and placing check marks in the following
button. This is necessary to refresh the
MITSUBISHI ELECTRIC
-20SSC-H BFM
3U
462080da.eps