Restarting The Terminal; Entering Safe Mode For Troubleshooting - Honeywell dolphin 75e User Manual

Hide thumbs Also See for dolphin 75e:
Table of Contents

Advertisement

3. Pull the battery latch back and remove the battery.
Battery Latch
4. Insert the new battery and install the battery door.
5. Apply pressure to the edges of the battery door to ensure the door is properly closed. Engage the door lock.
6. Press the Power button
Important: All battery and connector doors must be present, undamaged, and properly closed to maintain the environmental
rating of the terminal.

Restarting the Terminal

You may need to restart the terminal to correct conditions where an application stops responding to the system or the terminal
seems to be locked up.
• Press and hold the Power button
To perform a restart if the touch panel is unresponsive:
• Press and hold the Power button
When the reset is complete, the Lock screen appears.
Note: The Internal storage\honeywell folder on the Dolphin terminal is semi-permanent storage on the terminal. By default, files
in this folder are maintained after a Reboot.

Entering Safe Mode for Troubleshooting

Safe mode disables all third party applications installed on the terminal. To enter safe mode, press and hold the Menu
button
when the unit is booting, and then select OK when prompted. To exit safe mode reboot the terminal.
Note: This mode may not be available if your system administrator has set policies to prevent its use.
.
until the options menu appears, and then select Reboot. Select OK to confirm.
f
or approximately 8 seconds until the terminal starts to reboot.
1 - 11

Advertisement

Table of Contents
loading

Table of Contents