Table of Contents
Advertisement
Restarting the terminal
Terminal resetting
ScanPal EDA50 Enterprise Hybrid Device User Guide
If the terminal or an application is locked or doesn't respond when pressing the
power key, you need to restart the terminal.
When restarting, the terminal will use the current configuration saved in the flash
memory. Try the following ways to restart the terminal:
•
Reset: Restart the terminal and initialize it
•
Restore to factory settings: Clear all data in the terminal, including all
applications and data files, but excluding built-in files or data stored in a
removable storage device.
When an application is not responding, you may need to restart the terminal to
resolve the issue.
1.
Save the file and close open applications.
2.
Press and hold "Power Key" until the following interface displayed:
3.
Tap Power off.
4.
Tap OK when message as "Your phone will shut down" pops up.
5.
Press down "Power Key" to restart EDA50.
7. Management and maintenance
69
Advertisement
Table of Contents
