Bottom Panel; Power; Connecting Power To The Ebase - Honeywell dolphin 75e User Manual

RJ45 Ethernet Port
Use a standard CAT-5 Ethernet cable; you can connect the ebase to an Ethernet-compliant device to facilitate Ethernet
communication to and from the terminal. The RJ45 connector includes integrated LEDs that provide Ethernet
communication status and speed information.
Status
No Ethernet Link
10Mbps Ethernet Connection Established
100Mbps Ethernet Connection Established
Data transfer in progress
DC Power Jack
See

Power

(below).

Bottom Panel

For details on how to mount the eBase, see
Compliance Label
Power
The base requires 12 Volts DC input for communications, battery charging, and power output to the terminal; the power adapter
included with the base converts the voltage from the AC power source to
12 Volts DC. Use only a UL listed power supply, which has been qualified by Honeywell with output rated at 12VDC and
3 amps with the device. The operating temperature range is -10° to 50°C (14° to 122°F). Honeywell recommends that you
leave the eBase connected to its power source at all times, so that it is always ready to use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.

Connecting Power to the eBase

1. Plug the A/C power cord into the power adapter.
2. Plug the power cable into the power jack on the back of
the eBase.
3. Plug the A/C power cord into a grounded power source.
9 - 4
Yellow LED
Off
Off
On
Connection Speed Dependent
(see above)
Mounting the eBase on page
A/C Power Cord
Green LED
Off
On
On
Flashing
9-7.
Serial Number Label
MAC Address Label
Power Adapter
Power Cable