Table of Contents
Advertisement
VGA drivers do not have to be installed when operating in DOS.
Changing the VGA settings requires running the program
"SVGAUTIL.EXE."
1. Insert the disk which contains the SiS 5598 DOS VGA Utilily
installation program
2. Run the setup program called "SVGAUTIL.EXE"
You should now see the screen for setting various VGA options:
a) Video Mode Setting,
b) Frame Rate Setting, and
c) Power Saving Setting.
3) Once you have made your changes, you can choose to save the
changes to the "AUTOEXEC.BAT" file or not.
A list of the different video modes that can be supported is displayed.
Be sure to first test the video mode, by highlighting the mode and then
by pressing <F1>, before making a final selection.
Much like the Video Mode Setting, a list of valid frame rate modes will
be displayed which includes the monitor display resolution and the
corresponding frame rate. Again, first press <F1> to test if the monitor
can support the frame rate before finalizing your frame rate selection.
Here you can set the timers for the Standby and Suspend power
saving modes. Highlight the "Standby Timer" or "Suspend Timer"
option to change the timer values.
9 8
PCM-5894/5892 User Manual
Advertisement
Table of Contents
