Table of Contents
Advertisement
You can attach up to two floppy disks to the mainboard controller.
You can use any combination of 5¼" (360 KB and 1.2 MB) and/or
3½" (720 KB, 1.44 MB, and 2.88 MB) drives.
A 34-pin daisy-chain drive connector cable is required for a dual-
drive system. On 1 end of the cable is a 34-pin flat-cable connector.
On the other end are two sets of floppy disk drive connectors. Each
set consists of a 34-pin flat-cable connector (usually used for 3½"
drives) and a printed-circuit board connector (usually used for 5¼"
drives).
1. Plug the 34-pin flat-cable connector into CN16. Make sure that
the red wire corresponds to pin 1 on the connector.
2. Attach the appropriate connector on the other end of the cable
to the floppy drive(s). You can use only one connector in the
set. The set on the end (after the twist in the cable) connects to
the A: drive. The set in the middle connects to the B: drive.
3. If you are connecting a 5¼" floppy drive, line up the slot in the
printed circuit board with the blocked-off part of the cable
connector.
If you are connecting a 3½" floppy drive, you may have trouble
determining which pin is pin number 1. Look for a number
printed on the circuit board indicating pin number 1. Also,
the connector on the floppy drive connector may have a slot.
When the slot is up, pin number 1 should be on the right.
Check the documentation that came with the drive for more
information.
If you desire, connect the B: drive to the connectors in the
middle of the cable as described above.
Chapter 2 Installation 37
Advertisement
Table of Contents
