Manually Moving The Scooter; Assembling The Scooter - CareCo ECLIPSE Owner's Manual

7.5 MANUALLY MOVING THE SCOOTER

 Switch off the power with power key before moving the scooter.
Always dismount from the scooter before moving.
 Lift the scooter by the chassis, and not by the shroud.
Lifting the scooter by the bumper could cause damage or injury.
 For your safety, always ask for assistance. Two people will be required to move or lift the
scooter. If assistance is not available, please disassemble the scooter before lifting.
Refer to section '4.5. DISASSEMBLING THE SCOOTER'.

7.6 ASSEMBLING THE SCOOTER

 Suggestion
The assembly process is essentially the disassembly process in reverse. First study the text
and photographs in '4.5 DISASSEMBLING THE SCOOTER' before re-assembling the scooter.
1. Loosen tiller adjustment knob, raise the tiller to the desired position, and then tighten the
tiller adjustment knob.
2. Reinstall the upper seat post at the desired height. Secure with the locking pin and
tighten the seat post knob.
3. Reinstall the batteries by lowering the pack into place.
4. Replace the seat and rotate it until it locks into its correct position.
 Warning
After assembling, make absolutely certain the tiller adjustment knob is fully tightened.
7 . I N S P E C T I O N A N D M A I N T E N A N C E
20