How To Set To Freewheel Mode - CareCo ECLIPSE Owner's Manual

 Suggestion
1. You should recharge the batteries after each time the vehicle is used to ensure maximum
range. The batteries should be fully charged at least once a week even if the scooter is not
used.
2. After charging or replacing a new battery, drive the vehicle for 2-3 minutes to make sure the
battery capacity is sufficient.
3. In winter, the batteries may respond more slowly and the range may be reduced.
4. When driving on a slope or hill, the battery indicator light might move up and down. This is
normal and there is no need for concern.
5. Even if the batteries are used properly, their capacity will reduce in time and this results in
reduced range compared to brand new batteries. When the batteries' range is approximately
50% of that when they were new, it is time to replace them. Please contact CareCo about
replacement batteries. If you continue to use old batteries when they should be replaced,
the performance of your scooter may be affected.
6. The battery range will be reduced when frequently driving uphill or on rough ground, as this
leads to greater consumption of power.
7. The batteries have a six-month warranty covering manufacturing defects. This warranty
does not cover faults due to incorrect battery recharging.
■ How to adjust the seat height
1. Remove the seat from your scooter.
2. Remove the lock bolt from the lower seat post.
3. Adjust the seat post to the desired seat height.
4. Move the upper seat post to show the hole to insert the lock bolt.

4.3 HOW TO SET TO FREEWHEEL MODE

◆ Engaged mode: Push the lever completely and the scooter can be driven by motor power.
◆ Freewheel Mode: Switch the scooter off. Pull the lever up and the scooter can be moved
manually.
4 . O P E R AT I O N
Lever
10