Connecting Dc Power Cords - HP HSR6800 Installation Manual

Figure 21 Connecting an AC power cord to the router

Connecting DC power cords

Connecting power cords for the PSR650-D
WARNING!
To avoid connection mistakes, identify the label on the DC power cord.
Figure 22 DC power cords
To connect DC power cords:
1. Switch off the power supply.
2. Remove the protection cover of the DC power module, and use a Phillips screwdriver to remove the
screws from the DC-input terminal block.
3. Connect the end marked with "– " to the negative terminal (–) on the DC-input terminal block and
fasten the screw.
4. Connect the end marked with "+" to the positive terminal (+) on the DC-input terminal block and
fasten the screw.
5. Connect the other end of each DC power cord to the DC power source.
6. Install the protection cover of the DC power module.
21