Displaying And Verifying Transceiver Modules - HP HSR6800 Installation Manual

To configure a combo interface:
Step
1. Enter system view.
2. Enter view of the SFP port or
RJ-45 port of the combo
interface.
3. Activate the RJ-45 Ethernet
port or SFP port.

Displaying and verifying transceiver modules

Table 19 Commonly used transceiver modules
Transceiver module type
SFP (small form-factor pluggable)
XFP(10-Gigabit small form-factor
pluggable)
SFP+ (enhanced small form-factor
pluggable)
Displaying transceiver module information
To identify transceiver modules, you can use the following command to view the key parameters of the
transceiver modules, including transceiver module type, connector type, central wavelength of the laser
sent, transmission distance, and vendor name or name of the vendor who customizes the transceiver
modules.
To display transceiver module information:
Task
Display key parameters of the
transceiver module in a specified
interface.
Verifying transceiver modules
The system outputs alarm information for you to locate and troubleshoot faults of transceiver modules. For
the HP-customized transceiver modules, the system can also monitor the key parameters, such as
temperature, voltage, laser bias current, TX power, and RX power. When these parameters are abnormal,
you can take corresponding measures to prevent transceiver module faults.
To display the alarming information or fault detection parameters of a transceiver module:
Command
system-view
interface interface-type
interface-number
combo enable { copper | fiber }
Application scenarios
Generally used for
100M/1000M Ethernet
interfaces or POS
155M/622M/2.5G
interfaces.
Generally used for 10G
interfaces.
Generally used for 10G
interfaces.
Command
display transceiver interface
[ interface-type interface-number ]
63
Remarks
N/A
N/A
By default, the fiber port is active.
Whether can be
Whether can be an
an optical
copper transceiver
transceiver
Yes. Yes.
Yes. No.
Yes. No.
Remarks
Available for all transceiver
modules.