2. To aim the camera, adjust each of the available camera heads as required:
a. Press the rail release tab to move the camera head side to side.
b. Loosen the tilt lock screws to tilt each camera head up and down. Lock the screws when the
camera is tilted in the correct angle.
c. Rotate the azimuth control ring to set the image in the correct rotation.
3. In the camera web browser interface, adjust the camera's Image and Display settings to achieve the
desired zoom position.
Installing the Dome Cover
1. Align the notches on the dome cover with the release tab on the base. The dome cover should be flush
against the camera base.
2. Slide the dome cover clockwise until it locks into place.
NOTE: Be careful not to scratch the dome bubble.
For More Information
Additional information about setting up and using the device is available in the following guides:
Avigilon™ Control Center Client User Guide
l
Avigilon™ High Definition H.264 Web Interface User Guide
l
The manuals are available on the Avigilon website:
12
http://avigilon.com/support-and-downloads
Installing the Dome Cover