Table of Contents
Advertisement
2. Pull the required cables through the conduit, then through the cable entry hole in the back panel.
3. After you make the cable connections, screw the back panel into place.
Connecting Cables
Refer to the diagrams in the Overview section for the location of the different connectors.
To connect the cables required for proper operation, complete the following:
1. If external input or output devices are part of the installation (for example: door contacts,relays, etc),
connect the devices to the I/O Terminals.
2. If an external microphone or speaker is required, connect the devices to the audio connector.
3. Connect power using one of the following methods:
Power over Ethernet (PoE) Class 3 — Connect a PoE compliant injector or switch to the Ethernet
l
network cable.
External Power — Connect an external "Class 2" or "LPS" or "Limited Power Source" with output
l
rated 24 V AC +/- 10%, 19 VA minimum or 24 V DC +/- 10%, 13 W minimum.
4. Connect a network cable to the Ethernet Port (RJ-45 connector).
The Link LED will turn on once a network link has been established.
5. Check that the Connection Status LED indicates the correct state. For more information, see LED
Indicators on page 16.
Assigning an IP Address
The camera automatically obtains an IP address when it is connected to a network.
8
Connecting Cables
Hide quick links:
Advertisement
Table of Contents
