Table of Contents
Advertisement
Figure 1:
Setting the clamp into ready position.
(Optional) Cutting the Mounting Hole
This procedure is not required if you are planning to install the camera with a metal ceiling panel.
1. Use the mounting template to cut a hole in the mounting surface.
2. Remove the mounting template and pull the required cables through the mounting hole.
(Optional) Configuring Onboard Storage
To use the camera's onboard storage feature, you must insert an SD card into the SD card slot.
It is recommended that the SD card have a capacity of 8GB or more, and a write speed of class 6 or better. If the
SD card does not meet the recommended capacity or write speed, the performance of the onboard storage
may suffer and result in the loss of frames or footage.
1. Loosen the screws that secure the camera module to the base.
2. Lift the camera module out of the base until the SD card slot is exposed. The camera module will only lift
up about 2cm or about 1" off the base because it is anchored behind the camera module. Do not pull too
hard.
6
(Optional) Cutting the Mounting Hole
Hide quick links:
Advertisement
Table of Contents
