(Optional) Configuring Onboard Storage; Optional) Configuring Onboard Storage; Installing The Dome Cover - Avigilon 1.0-H3-DC1 Installation Manual

4. Rotate the azimuth control ring to set the image to the
correct angle.
5. In the Avigilon Camera Installation Tool or camera web
browser interface, adjust the camera's Image and Display
settings to achieve the desired zoom position.

(Optional) Configuring Onboard Storage

To use the camera's onboard storage feature, you must insert an SD
card into the SD card slot. Avigilon offers a line of SD cards that have
been fully tested with this camera to ensure optimal SD card
performance. For ordering information, please refer to the Avigilon
price list.
It is recommended that the SD card have a capacity of 8GB or more,
and a write speed of class 6 or better. If the SD card does not meet the
recommended capacity or write speed, the performance of the
onboard storage may suffer and result in the loss of frames or footage.
1. Insert an SD card into the camera.
Caution — Do not force the SD card into the camera or you
may damage the card and the camera. The SD card can only
be inserted in the direction shown on the camera.
2. Access the camera's web interface to enable the onboard
storage feature.
For more information, see the Avigilon High Definition
H.264 Camera Web Interface User Guide.

Installing the Dome Cover

To install the dome cover, complete the following steps:
1. Rotate the black shield located inside the dome bubble so
that it does not block the camera's field of view.
2. Attach the dome cover to the base by tightening the 2
tamper-proof screws. Use the tamper resistant key
included in the dome camera package to tighten the
screws. Be careful not to scratch the dome bubble.
9