Procedure Used To Lower The Pressure In The Fuel System Instruction 1 - PEUGEOT TSDI Workshop Manual

Procedure used to lower the pressure in the fuel
system instruction 1
Imperative: wash the power unit
- Remove the saddle/locker assembly
- Raise the fuel tank in order to with draw the
injection manifold (1) soundproofing.
- Disconnect the fuel injector (2)
- Remove the 2 bolts (3) from the injection
manifold (4)
- Remove the injection manifold without
disconnecting the feed pipes (5)
- Connect the fuel injector harness tool P/N 756017
to the fuel injector and the battery
- Put the manifold into a container (6) to catch the
fuel
- Operate the tool contactor 5 times stopping for 5
seconds between each operation in order to lower
the pressure in the injection manifold feed pipe
Correctly secure the injection rail in the
container as the pressurised fuel jet may be
dangerous for the skin, do not expose the hands
to the petrol jet when the injector is opened
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
SPECIAL WORK AND PROCEDURES
Page: 31