To Remove The Strainer - PEUGEOT TSDI Workshop Manual

To remove the strainer

- Remove the ignition key after unlocking the
saddle
- Remove the saddle/locker assembly
- Empty the fuel tank proceeding as follows:
- Disconnect the vent (A) pipe (1) from the gauge
(2) and put into a container in order to drain out the
fuel
- Reconnect the pipe (1) once the tank is empty
- Disconnect the fuel gauge
- Unscrew and remove the fuel gauge (2) with its
seal using tool P/N 756056
- Remove the strainer (3) by passing one hand
inside the gauge well, wearing a protective glove
- Clean or change the strainer in accordance with
the service instructions
Re-assembly: Re-assemble in the reverse order to
dismantling
- Tighten the fuel gauge with the ring spanner P/N
756056 in order to line up the arrow with the
centring mark on the tank
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
SPECIAL WORK AND PROCEDURES
Page: 38