To Remove The Ht Coil; Setting The Spark Plug Electrode Gap - PEUGEOT TSDI Workshop Manual

To remove the HT coil

- Remove the ignition key after unlocking the
saddle
- Remove the saddle/locker assembly
- Disconnect the suppressor (1)
- Remove the rubber washer (2) and the suppressor
rubber cap (3)
- Remove the spark plug lead from the 2 plastic
clips (4)
- Remove the high tension coil 2 bolts from the
right -hand side of the machine
- Disconnect the high tension coil
- Remove the coil (5)
Re-assembly: Re-assemble in the reverse order to
dismantling
Check: Connect the diagnostic tool and check there
are no fault codes, erase them if necessary

Setting the spark plug electrode gap

The spark plug electrode gap setting is between 0.5
and 0.6 mm
Spark plug protrusion check
±0,4
B=3,5 mm
The position of the spark plug electrode in the
combustion chamber is important therefore it is
essential that the spark plug setting is correct. If one
of these values cannot be obtained, the plug must be
changed
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
SPECIAL WORK AND PROCEDURES
Page: 40