To Fit The Magneto Flywheel; To Remove The Cooling System - PEUGEOT TSDI Workshop Manual

- Fit the bolt-washer, cylinder head and gasket
assembly to the cylinder
- Tighten the 4 bolts in 2 or 3 steps in the order
shown
Note: this operation is carried out without
removing the air injector

To fit the magneto flywheel

- Fit the key (1) to the crank
- Fit the stator (2) and engine speed sensor (3)
assembly
- Fit the 2 fixing bolts for each of the parts
- Fit the rotor to the crank ensuring it is perfectly
positioned on the key
- Lock the rotor with the adjustable pin wrench
P/N 752237
- Fit and tighten the rotor nut

To remove the cooling system

- Fit the cooling turbine and its 3 bolts
- Fit the volute and cylinder cover (1) with the 4
bolts (2)
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
REFITTING SPECIFIC COMPONENTS
Page: 25