Assembling The Casings - PEUGEOT TSDI Workshop Manual

Assembling the casings

- Insert the crank into the LH casing bearing
- Tighten pin P/N 750069 on the end of the crank
- Fit tool P/N 64706 fitted with plate P/N 755984
to the pin and centre the assembly on the casing
with the 4 bolts (1)
- Fit centring tool P/N 64710 to tool P/N 64706
- Tighten pin nut P/N 69104 on pin P/N 750069 in
order to bring the crank into contact with the
bearing ensuring that the connecting rod is facing
towards the top of the engine
Note: hold the crank on the RH side with the rotor
fitted over the key
- Fit the two locating dowels (2) and a new paper
gasket (3) with no oil or grease to the LH casing
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
REFITTING SPECIFIC COMPONENTS
Page: 21