To Fit The Magneto Flywheel; To Remove The Coil Assembly And The Stator - PEUGEOT MOTOR ENGINE Workshop Manual

To fit the magneto flywheel

Coil assembly support
- Fit the half-moon key (9) into its housing in the
crank assembly straight section
- Fit the stator plate (7) and its 2 bolts
Type 1: 6-pole assembly
- Fit the coil assembly (5) and its two bolts (3) and
the sensor (6) two bolts (4)

To remove the coil assembly and the stator

Type 2: 4-pole assembly
- Fit the coil assembly (5) and its 2 bolts (3)
Reproduction or translation, even partial, forbidden without the written consent of Peugeot Motocycles
REASSEMBLY
Page: 31